Powersoft has announced the introduction of M Series DSP+ETH power amplifiers outfitted with 24-bit/48 kHz AD/DA converters with 56-bit for internal processing.
With two inputs and outputs each for the 2-channel version and four inputs and outputs each for the 4-channel version, the system offers per channel five bi-quad filters for system equalization, eliminating the need for outboard equalizers, plus two crossovers and eight bi-quad filters.
Each channel has dual dynamic processors with arbitrary input/output curve and adjustable time constants. To accommodate loudspeaker time alignment, a generous range from zero to 10 ms adjustable delay makes timing the low frequency vs. high frequency speakers easy.
The DSP engine delivers up to 114 dB(A) signal to noise ratio (analog in/out) with a 1 ms processing delay time. It also provides a complete set of limiters: Peak with varaiable ratio, RMS, and frequency shaping RMS.
The high-performance DSP card also offers FIR/IIR filters for accurate crossover control for bi-amped loudspeakers. Crossover filter types include Butterworth, Linkwitz-Riley and Bessel, with adjustable 6 dB to 48 dB per octave roll off.
As the DSP card resides inside the amplifier, settings are safe from accidental or intentional tampering, with monitoring of vital system and amplifier data done via Armonía Pro Audio Suite software. M Series amplifiers access Armonía with the same Ethernet network interface as all Powersoft amplifiers allowing for preset management and uploading over a network. Locally, the M Series DSP+ETH permits the user to address up to four presets on the rear panel via pushbutton.
M Series DSP+ETH comes in three 2-channel (M30D DSP+ETH, M20D DSP+ETH, M14D DSP+ETH) and two quad (M50Q DSP+ETH, M28Q DSP+ETH) versions. Each amplifier is housed in a one rack unit, rugged metal case weighing in at 16.3 Lbs (7.4 Kg).
Powersoft bridgeable switch mode fixed frequency Class D patented outputs provide high quality sound, outstanding damping factor and cooler circuits for stable performances over time for a longer amplifier life and reduced operational costs from power draw and HVAC cooling.
Most M Series DSP+ETH models are able to drive 70V/100V constant voltage lines directly without the need of transformers. However, optional TU4 single rack units providing 4-channel transformer outputs may be used for galvanic insulation and other operational voltages not supported by the M Series DSP+ETH amplifiers directly.
The M Series DSP+ETH runs extremely efficiently, making on site AC mains distribution vastly easier, especially for live sound applications. Because of available EQ and crossover filters, sound companies and bands no longer need to carry extra outboard gear thereby reducing hauling weight. Both fixed installation and touring benefit from streamlined system wiring.
The two four-channel models provide up to 1250 watts per channel on 4 ohm loads, while the three two-channel models offer a maximum output of 1500 watts per channel on 4 ohm loads, while full range can reach up to 360 watts per channel on 8 ohm loads.
“The new M Series DSP+ETH amplifiers give the end user access to Powersoft’s digital signal processing engine technology, Ethernet connectivity and system monitoring and control through our powerful Armonía Pro Audio Suite software,” says Ken Blecher, executive vice president of Powersoft Audio Technologies Corp. “The introduction of DSP+ETH was the next logical developmental step to give the growing family of M Series users nearly the same level of flexibility and control enjoyed by our flagship K Series owners. The M Series DSP+ETH represents incredible value for performance, making it the amplifier of choice for the small to medium installation or touring sound system.”
