Studio Recording

Supported By

In The Studio: Troubleshooting Drum Sounds

Each situation is different and ultimately the sound depends upon the drums, the drummer, the song, the arrangement, and even the other players.

Like the foundation of a house, the drums are the foundation of a recording. When it’s strong, you can build almost anything on it that you or your clients can imagine. That said, sometimes you just can’t find the right drum sound and can’t figure out why.

Here’s an excerpt from the 4th edition of my Recording Engineer’s Handbook that provides a list of things to check if your drums just don’t sound right.

Remember that each situation is different and ultimately the sound depends upon the drums, the drummer, the song, the arrangement, and even the other players. Sometimes things are just out of your control. Also, these are not hard and fast rules, just a starting place. If you try something that’s different from what you’ll read below and it sounds good, it is good!

Do the drums sound great acoustically?

Make sure that you start with a great acoustic drum sound with the drums well tuned and minimum of sympathetic vibrations.

Are the mics acoustically in phase?

Make sure that tom mics and room mics are parallel to each other. Make sure that any underneath mics are at a 45° angle to the top mics.

Are the mics electronically in phase?

Make sure that any bottom mics have the phase reversed. Make sure that all the mic cables are wired the same by doing a phase check.

Are the mics at the correct distance from the drum?

If they’re too far away they’ll pick up too much of the other drums. If they’re too close the sound will be unbalanced with too much attack or ring.

Are the drum mics pointing at the center of the head?

Pointing at the center of the drum will give you the best balance of attack and fullness.

Are the cymbal mics pointed at the bell?

If the mic is pointed at the edge of the cymbal, you might hear more air “swishing” than cymbal tone.

Is the high-hat mic pointed at the middle of the bell?

Too much towards the bell will make the sound thicker and duller. Too much towards the edge will make the sound thinner and pick up more air noise.

Are the room mics parallel?

If you’re using two room mics instead of a stereo mic to mic the room, make sure that the mics are on the same plane and are exactly parallel to each other. Also make sure that they’re on the very edge of the kit looking at the outside edge of the cymbals.

Does the balance of the mix sound the same as when you’re standing in front of the drums?

This is your reference point and what you should be trying to match. You can embellish the sound after you’ve achieved this.

The drum sound is essential to a great sounding mix, and following the above checklist can help get you where you want to go.

You can read more from The Recording Engineer’s Handbook and my other books on the excerpt section of bobbyowsinski.com.

Read and comment on the original article here.

Study Hall Top Stories

Supported By

TELEFUNKEN Elektroakustik’s mission is to design and build iconic microphones and modern professional audio equipment that provides classic sound for recording, broadcast, studio, and stage . Our vision is to be a global leader in emitting good vibes through manufacturing and design, all while capturing the spark of the TELEFUNKEN legacy and transmitting it with uncompromising quality.