By Bobby Owsinski • January 4, 2017 Legendary recording engineer Al Schmitt. (Photo courtesy of Capitol Studios) This article is provided by Bobby Owsinski. After 18 Grammys for Best Engineering (more than any other engineer) and work on over 150 gold and platinum records, Al Schmitt needs no introduction to anyone even remotely familiar with the recording industry. Indeed, his credit list is way too long to print here (but Henry Mancini, Steely Dan, George Benson, Toto, Natalie Cole, Quincy Jones, and Diana Krall are some of them), but suffice it to say that Al’s name is synonymous with the highest art that recording has to offer. Here’s an excerpt from my Recording Engineer’s Handbook that covers his usual microphone setup. ——————————————— Do you use the same setup every time? I usually start out with the same microphones. For instance, I know that I’m going to immediately start with a tube U 47 about 18 inches from the F-hole on an upright bass. That’s basic for me and I’ve been doing that for years. I might move it up a little so it picks up a little of the finger noise. Now if I have a problem with a guy’s instrument where it doesn’t respond well to that mic then I’ll change it, but that happens so seldom. Every once in a while I’ll take another microphone and place it up higher on the fingerboard to pick up a little more of the fingering. The same with the drums. There are times where I might change a snare mic or kick mic, but normally I use a D-112 or a 47 FET on the kick and a 451 or 452 on the snare and they seem to work for me. I’ll use a Shure SM57 on the snare underneath and I’ll put that microphone out of phase. I also mic the toms with 414’s, usually with the pad in, and the hat with a Schoeps or a B&K or even a 451. What are you using for overhead mics? I do vary that. It depends on the drummer and the sound of the cymbals, but I’ve been using M 149s, the Royer 121s, or 451s. I put them a little higher than the drummer’s head. Do you try to capture the whole kit or just the cymbals? I try to set it up so I’m capturing a lot of the kit, which makes it a little bigger sounding overall because you’re getting some ambience. What determines your mic selection? It’s usually the sound of the kit. I’ll start out with the mics that I normally use and just go from there. If it’s a jazz date then I might use the Royers and if it’s more of a rock date then I’ll use something else. How much experimentation do you do? Very little now. Usually I have a drum sound in 15 minutes so I don’t have to do a lot. When you’re working with the best guys in the world, their drums are usually tuned exactly the way they want and they sound great, so all you have to do is capture that sound. It’s really pretty easy. And I work at the best studios where they have the best consoles and great microphones, so that helps. I don’t use any EQ when I record. I use the mics for EQ. I don’t even use any compression. The only time I might use a little bit of compression is maybe on the kick, but for most jazz dates I don’t. How about mic preamps? Do you know what you’re going to use? Do you experiment at all? I know pretty much what I’m going to use. I have a rack of Neves that I’ll use on the drums. How do you handle leakage? Do you worry about it? No, I don’t. Actually leakage is one of your best friends because that’s what makes things sometimes sound so much bigger. The only time leakage is a problem is if you’re using a lot of crap mics. If you get a lot of leakage into them, it’s going to sound like crap leakage, but if you’re using some really good microphones and you’re get some leakage, it’s usually good because it makes things sound bigger. I try to set everybody, especially in the rhythm section, as close together as possible. I come from the school when I first started where there were no headphones. Everybody had to hear one another in the room, so I still set up everybody up that way. Even though I’ll isolate the drums, everybody will be so close that they can almost touch one another. Bobby Owsinski is an author, producer, music industry veteran and technical consultant who has written numerous books covering all aspects of audio recording. For more information be sure to check out his website, and go here for more info and to acquire a copy of The Recording Engineer’s Handbook. About Bobby Bobby Owsinski Music Industry Veteran and Technical Consultant Bobby Owsinski is an author, producer, music industry veteran and technical consultant who has written numerous books covering all aspects of audio recording. To read more from Bobby, and to acquire copies of his outstanding books such as The Recording Engineer’s Handbook, be sure to check out his website at www.bobbyowsinski.com. http://www.bobbyowsinski.com/ Comments Have something to say about this PSW content? Leave a comment! Cancel reply Scroll past the ”Post Comment” button below to view any existing comments. Your email address will not be published. Required fields are marked *Comment Name * Email * Website This site uses Akismet to reduce spam. Learn how your comment data is processed. Tagged with: Al Schmitt Best Practices Bobby Owsinski Engineer Instruments Microphone World Microphones Recording Studio Techniques · all topics Subscribe to Live Sound International Subscribe to Live Sound International magazine. Stay up-to-date, get the latest pro audio news, products and resources each month with Live Sound. Subscribe Today!