Loudspeakers
Sponsored by
Meyer Sound

Road Test: XIRIUM PRO

Evaluating a new wireless loudspeaker distribution platform from Neutrik

By Mike Sokol July 1, 2016

The new XIRIUM PRO wireless distribution system from Neutrik.

Cables are the bane of our existence as sound technicians. Can’t live with ‘em, and can’t live without ‘em.

On many gigs I can have upwards of 100 XLR cables, which get used for everything from stage microphones and DI boxes, to sending audio to active loudspeakers for monitors, FOH, and delays.

But while running XLR cables to the loudspeakers is certainly the least expensive and possibly most robust solution, many times it’s too cumbersome and creates logistical nightmares. For instance, running XLR cables across a busy street is prone to all kinds of failure mechanisms and may require special permits in some locals.

On the other hand, RF-based loudspeaker distribution is a cruel master. If you think a street is a busy place, the RF spectrum is assaulted with all kinds of traffic. Every kid with a cell phone, remote printers, Wi-Fi networks, and even Bluetooth ear pieces all fight for the same piece of RF turf, the 2.4 GHz spectrum. And the UHF bands aren’t much better, where a visiting guitar player with a rough wireless system can step on your carefully laid-out RF mic setup.

So if you’re going to use RF instead of cable to run concert sound hundreds of feet to a remote loudspeaker location, it had better be rock solid. Hey, if one mic has an RF dropout you might get away with it, but if an entire loudspeaker stack goes down because of an RF hit, it’s a real show-stopper.

With that in mind, I recently asked Neutrik to send me its new XIRIUM PRO wireless distribution system for review, with Mark Boyadjian of Neutrik also showing up for a real gig to show me how it works. Here are the system components utilized in this evaluation:

(1) NXP2TX transmitter base station
(4) NXP2RX receiver base stations
(1) NXP-TM-ANA analog TX module
(3) NXP-RM-ANA analog RX modules
(1) NXP-RM-RP repeater module

It all arrived in a pair of road cases all ready to pack on the truck. But first I was instructed to charge the modules up overnight. According to Neutrik, battery life should be about 10 hours on a full charge, but I like to use AC whenever possible. Note: These units use Neutrik’s new powerCON TRUE1 AC connectors, which we’ll cover in a future article.

Capabilities & Options
Basically, each XIRIUM PRO unit includes either a 5 GHz transmitter or receiver for the audio path, as well as a 2.4 GHz transceiver for system communication and control. This allows setting up and monitoring audio communications using a free tablet app (iOS or Android).

The tablet screen provides a view of important things such as signal strength and dropped audio packets, plus insert delays needed for remote loudspeakers located downstream from the mains. 


Read the rest of this post

1
2


About Mike

Mike Sokol
Mike Sokol

System Designer & Audio Educator
Mike Sokol does sound system design and training for JMS Productions, his consulting company in Western Maryland. Visit www.livesoundadvice.com for his educational articles and videos, and email him at [email protected] with comments and suggestions.
http://www.livesoundadvice.com

Comments

Have something to say about this PSW content? Leave a comment!

Scroll past the ”Post Comment” button below to view any existing comments. Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.

Chris Mehalso says

Great article Mike! I agree that Xirium sounds "as good as a cable", but once you start getting out to longer lengths in severe environments, I'd even say that Xirium outperforms a cable! Issues like throughput latency, overal fidelity, signal drops, and cost of damage are actually eliminated by using Xirium instead of praying your XLR cables survive a big show. Good for the listeners, good for the client, and good for the equipment owner. Thanks for the info!

Tagged with:

Subscribe to Live Sound International

Subscribe to Live Sound International magazine. Stay up-to-date, get the latest pro audio news, products and resources each month with Live Sound.