Study Hall
Sponsored by
Audio Technica

Series Or Parallel? Linking Loudspeakers Properly

When connecting loudspeakers: whatever the approach, impedance is the thing

By Pat Brown September 14, 2012

Multiple loudspeakers can be connected in series or parallel to the output of the amplifier.

In either case, the current drawn from the amplifier is determined by the total impedance of the load as presented to the loudspeaker terminals.

Impedance is the opposition to the flow of current.

As the load impedance is decreased, the load on the amplifier is increased, because it must work harder to supply the demand for current. In similar fashion, an automobile trying to maintain its speed uphill is under a greater load than on flat ground.

A “no load “condition means that nothing is hooked to the amplifier, so no current flows and no power is transferred.

The opposite condition, a dead short between the amplifier “+” and “-” terminals, represents the maximum load possible, and current flow is limited only by the resistance of the wire making the connection.

So, the lower the impedance the greater the load – a bit counter intuitive but nonetheless true.

An example will clarify this. Imagine a bucket full of water.

Two loudspeakers in parallel require twice the current of a single one, just like two holes in a bucket offer one-half the opposition to water leaving the bucket as a single one. (click to enlarge)

Assuming watertight construction (a good thing for a bucket), there will be no water leaving the bucket (analogous to current flow), and the pressure against the sides of the bucket (analogous to electrical voltage) will be constant.

Now, let’s put a hole in the bucket. Water will now leave the bucket at a rate proportional to the size of the hole.

The hole represents the connection of a loudspeaker – current now flows from the bucket (amplifier) through the hole (load).

If we keep the hole relatively small, the pressure will be similar to the water-tight condition. If we replenish the bucket continually, the flow can continue indefinitely.

Read the rest of this post


About Patrick

Pat Brown
Pat Brown

Principals, Synergetic Audio Concepts
Pat & Brenda Brown lead SynAudCon, conducting audio seminars and workshops online and around the world. For more information go to


Leave a Reply

Your email address will not be published. Required fields are marked *

Tony says

“As the load impedance is decreased, the load on the amplifier is increased, because it must work harder to supply the demand for current.” 

This is a mis-leading and borderline inaccurate statement.  This implies that the speakers are demanding a certain level of current which is not the case.  The speakers resist current (impedance) but the lower the impedance the more current is allowed to flow from the amplifier.

Tony says

Seriously disappointing article.  The concepts are important but sloppy use of terminology will lead to more confusion than any assistance in understanding. 

Speakers don’t draw current.  Lower impedance is a smaller load (not bigger).  The lower impedance results in higher current flow per Ohm’s law. 

Maybe this sloppy vocabulary was used to try and simplify the concepts but in the end it just perpetuates the myths that cause the confusion on this topic in the first place.

Tagged with:

Subscribe to Live Sound International

Live Sound International brings you information on a wide range of pro audio topics. Stay up-to-date, get expert tips, industry news, new products and technologies delivered.

Discover how to make smart use of today’s sound technology, Subscribe Today!

Latest in HOW!