Sign up for ProSoundWeb newsletters
Subscribe today!

Why Should We Care About Power Amplifier Clipping?
+- Print Email Share RSS RSS

Clipping means that the tops of the signal are “clipped off” or “flat-topped” when the signal level is exceeding the maximum capability of the power amplifier or some other piece of equipment in the system.

During the times when a signal is flat-topped, loudspeaker cones are not being “instructed” to move as it is receiving essentially a DC signal. This means all power goes into heating up their voice coils instead of producing sound.

In other words, during the times the signal is flat-topped a loudspeaker is 100 percent efficient at converting power into heat. Ironically, the more efficient the driver, the worse the problem. A horn tweeter (~25 percent efficient) normally converts 75 percent of its input power to heat. During clipping it must convert 25 percent more power to heat.

A cone woofer (~3 percent efficiency) normally converts 97 percent of its input power to heat. During clipping, it has to convert a mere 3 percent more to heat.

Now you know why tweeters burn out much more easily!

THERMAL INERTIA:

A hidden consequence of clipping is that, while high frequency drivers are more efficient in converting electrical power to sound, they have less mass than low frequency drivers.

Mass translates into thermal inertia. The higher the thermal inertia the more it takes to change the temperature of the mass. This means that high frequency drivers can heat up faster than low frequency drivers.

This is especially true during clipping because the driver is converting all its input power from the amplifier into heat while the signal is clipped.

CLIPPING FACTS:

—Any clipped signal can blow a loudspeaker. It does NOT matter if it is caused by the mixer, amplifier OR any other piece of equipment in the system OR whether the amp is at full output.

—Clipping cannot be detected by electronic or built-in loudspeaker protection circuits and therefore cannot prevent damage from clipping.

—Loudspeaker power ratings are valid for un-clippped input signals.

—Watch those clip indicators on every piece of equipment to avoid ANY clipping.


Commenting is not available in this weblog entry.