Sign up for ProSoundWeb newsletters
Subscribe today!

Forums Presented By: 
The Studio Curmudgeon: Gain Structuring With Plug-Ins
Computer-based recording can make it all too easy to miss a poorly thought-out signal chain
+- Print Email Share RSS RSS

In the pre-DAW era, when we had to rewind heavy two-inch multitrack tapes uphill in the snow, both ways, the concept of gain structure was fairly easy to grasp.

Instead of a virtual studio-in-a-box, each individual component was a link in the audio chain, visibly connected by patch cables, and analog distortion was fairly easy to hear, identify and track down.

In today’s digital world, it’s no longer that simple. Signal paths can be virtual, unconventional, and convoluted, and digital distortion can be subtle, sneaking up on you only after it’s too late to fix.

But while digital audio has fundamentally changed the way we record and mix, proper gain structure is no less critical to a good sounding recording.

The user-friendly, preset-heavy paradigm of computer-based recording can make it all too easy to miss a poorly thought out signal chain, leaving you with some nasty digital artifacts in the final mix, long after your star players have gone home or logged off.

Nothing (And Everything) To Gain

From its initial capture to its place in the final mix, every sound in a typical multitrack recording travels though a multitude of stages and devices. Each one of these stages, whether hardware or software, requires an optimal signal level at its input. Too high an input level can cause clipping and distortion; too low a level can add noise. Keeping an eye on the input and output levels of every stage in the signal chain is critical to ensuring that each device’s output feeds a clean signal to the next device’s input.

With the exception of devices connected via channel inserts, input levels for most plug-ins are controlled via the (hardware or software) mixer’s Aux or FX Send. Most plug-ins also have their own input level, so it’s important to look at both, and match the mixer’s FX send level with the plug-in’s input level for proper gain structure.

Sending too low a level to the effects bus and then turning up the plug-in’s input level to compensate will result in a nosier signal. Conversely, sending too hot an effects send level and then turning down the plug-in’s input level will result in a distorted signal. In most cases, it’s best to start with both levels set to 0 or unity gain.

In fact, with the exception of compressors and other dynamics processors, unity gain is a good rule of thumb – your signal level should ideally be unchanged whether the plug-in is inserted into the chain or not. If your levels are noticeably higher or lower when you bypass a particular device, it’s a good idea to go back and examine the gain structure of that link.

If A Signal Clips In The Forest…

Overloading can be particularly problematic in the digital domain. Raise the input signal to an analog device, and distortion will gradually rise until clipping occurs. Digital circuitry has no such safety zone – a single dB too high will take your signal from squeaky clean to nasty distortion.

Unlike analog distortion, digital clipping can be difficult to hear, particularly when it’s just one element of a complex multitrack mix. If the clipping goes undetected, the digital information for that sound is permanently corrupted, even if the levels are brought back down later in the mix. And digital distortion can have a subtle but undesirable effect on the sonic quality of your track, usually in the form of barely perceptible levels of a brittle, harsh digital sheen that can fatigue your listeners.

Even a relatively minimal amount of gain from certain plug-ins – for example, a high-pass filter – can boost peaks and transients pretty significantly. Don’t depend on your meters to alert you to these, either.

In most DAW setups, plug-in inserts occur pre-fader, so even if you keep the levels of your channel strips below clipping, distortion within a given plug-in may not show up if the level was brought back down further along the signal chain. As always, your ears are your most important tools. Solo each device and listen.


Commenting is not available in this weblog entry.