Sign up for ProSoundWeb newsletters
Subscribe today!

Forums Presented By: 
Tech Tip Of The Day: Getting That Great Kick Drum Sound
Six tips to make recording and mixing kick drum virtually painless...
+- Print Email Share RSS RSS

Provided by Sweetwater.

 
Q: I’ve been recording and mixing a Christian band the past few months and everyone is really happy with the results except for one thing: the kick drum.

Is there anything I can do? Or, if there isn’t, what should I know so I don’t have this problem ever again?

A: While there are a limited number of solutions to your problem once the instruments has been tracked, lets run through our top six tips for recording and then mixing a great kick drum.

First, and probably most obvious is to experiment with mic placement during tracking. Try to get as close to the sound you want with the mic before you add any EQ.

Take a look at where the drum beater is contacting the head, and mic to capture that attack. How far in or out of the drum you place the mic will have a large effect on the tone you capture. Further out will give you a more “resonant” or “woody” tone, while closer up should give you more attack, with less of the drum’s shell.

Second, try miking from the beater side of the drum in addition to your normal kick drum mic placement (assuming you are currently miking from in front of or inside the drum). This should give you more attack.

A few caveats: Watch for phase problems, be careful with mic placement and pickup pattern to avoid getting too much of the underside of the snare, and be sure that the kick pedal is squeak free!

Third, try using a different beater. One made of a harder material may give you more slap. We’ve even heard of drummers and engineers taping hard materials to the kick drum head where the beater strikes it to emphasize the “click” and beater attack.

Fourth, take a look at your musical arrangement. Are there other instruments in the kick drum’s frequency range that are masking it, diminishing its punch? Getting a kick drum and a bass guitar or bass synth to “sit” together in a mix is a real art. Maybe the problem is not in your kick, but in the bass EQ?

Fifth, try adding a little EQ. A parametric (or console EQ with sweepable mids) works well for this application, but a graphic can work fine. Boost the gain on the EQ, listen to the kick, and slowly sweep the EQ frequency until you find the frequency you want to bring out.

Next, adjust the EQ gain to your taste. In addition to boosting some frequencies, you might want to experiment with cutting some of the boomier frequencies out to clear the top end a bit.

And finally (or, some might say sixth) as you are trying various things, work at low volume levels. If the kick drum sounds good to you at low volume, it will probably sound even better when the level is wound up a bit.

For more tech tips go to Sweetwater.com


Source: Sweetwater

Comments (3) Most recent displayed first
Posted by Chris  on  10/11/10  at  12:56 PM
I once had to record a kick with no hole in the res head and no dampening to speak of and everything else wrong with it that you could think of (drummerloved it for some reason). I used a big cardboard box lined with foam with an AKG D12E inside covered with heavy blankets to isolate it as much as I could. At mixdown I doubled the track and compressed the copy at 8:1 with a quick attack and a moderate release and set the threshold so the compressor was really working. I eq'ed the copy to compliment the original and brought it up in the mix to fill in what the original lacked. It worked out really well but it took a while to dial in.
Posted by Tyler Smith  on  10/11/10  at  09:33 AM
Maybe, if your recorded kick drum is altogether not salvageable, try drum replacing the kick. Or, at least you might try doubling with a kick sample from your library. I make hip hop, so this was the first thing that came to mind.
Posted by Karl (Acoustic Butler) Freudenreich  on  10/11/10  at  09:12 AM
The article has lots of good ideas of what to try. But remember the adage... Garbage in Garbage out. does the kick sound good acoustically before the mic? If you have a kick with a bad sound to begin with you're putting yourself behind the 8 ball. (not the one by B.L.U.E. But it might not be a bad choice for a Kick drum).

Get the drum sounding good without a mic and recording it will be much easier.

Commenting is not available in this weblog entry.