Sign up for ProSoundWeb newsletters
Subscribe today!

Forums Presented By: 
Swtichcraft Debuts New SC800 Instrument Direct Box (DI)
Can be connected to audio consoles, mic preamplifiers, effects processors, and other equipment with three-pin XLR inputs
+- Print Email Share Comments (0) RSS RSS

The new Switchcraft SC800 instrument direct box converts the outputs of high impedance line level audio devices and musical instruments to low impedance, balanced and isolated mic level signals that can be connected to audio consoles, microphone preamplifiers, effects processors, and other equipment with three-pin XLR inputs.

SC800 Technical Specifications:

All measurements were taken with a 25 Ohm source into a 1 kOhm load measured on XLR output.

Common Mode Rejection
Greater than 100 dB at 60 Hz

Input Impedance
Greater than 150 kOhm at 1 kHz

Output Impedance
Less than 170 Ohm at 1 kHz

Phase Response
Less than 3 degrees at 20 Hz
Less than 1 degree at 1 kHz
Less than 16 degrees at 20 kHz

Total Harmonic Distortion + Noise
Less than .05 percent (At 20 Hz, +4 dBu)
Less than .006 percent (At 1 kHz, +4 dBu)

Maximum Input Level
+21 dBu (At 2 0Hz with 1 percent THD)
+41 dBu (With 20 dB pad engaged)

Frequency Response
10 Hz to 40 kHz (+/-0.3 dB, ref 1 kHz)

Voltage Gain
-23 dB
-43 dB (With 20 dB pad engaged)

The SC899 is hand-built in Chicago, Illinois, USA.

Switchcraft Website


With LiveSound, You Can Make Anyone Sound Good

A free subscription to LiveSound International is your key to successful sound management on any scale — from a single microphone to a stadium concert. Written by professionals for professionals, each issue delivers essential information on the latest products specs, technologies, practices and theory.
Whether you’re a house monitor engineer, technical director, system technician, sound company owner, installer or consultant, LiveSound International is the best source to keep you tuned in to the latest pro audio world. Subscribe today…it’s FREE!!

Commenting is not available in this weblog entry.