Sign up for ProSoundWeb newsletters
Subscribe today!

More Than One Way: Alternatives To High-Voltage Audio Power Distribution
This method is best understood by looking at the workings of a traditional power amplifier
+- Print Email Share RSS RSS

In audio terms, high voltage means that the output power of the amplifier is converted to a high-voltage/low-current signal for transmission over long distances and/or small wire gauges.

The advantages of the method include low cost and rather “bulletproof” systems, and the downside is that the transformers required present yet another filter for the signal to pass through, often degrading the audio quality.

Since loudspeaker lines should always be kept as short as possible, the ultimate realization of this involves placing the amplifier right at the loudspeaker, connected to it by inches of cable.

This method is best understood by looking at the workings of a traditional power amplifier. There are many shapes and sizes, but they all have some commonalties.

First, all amplifiers take AC power (alternating current) and use it to amplify signals. This requires converting the 60 Hz sinusoidal signal from the power company into something that looks like the audio signal that we wish to amplify. Several steps are required to accomplish this.

To begin with, the voltage component of the power is transformed from 110 or 220 volts (common distribution voltages) into the voltage required by the amplifier circuitry, which is determined by the power rating of the amplifier.

Next, the new value of voltage and current is rectified into DC (direct current). In DC form, the power can be “modulated” by the audio signal voltage to form a higher-power facsimile of the input signal voltage to the amplifier. This step is accomplished by the output stages of the amplifier.

Figure 1 (below) shows the parts of a typical power amplifier. Conventional systems take the amplified output of the power amplifier and feed it to loudspeakers through a wire gauge of sufficient size to minimize the power loss to 0.5 dB.


When the required wire gauge becomes too large, the power is delivered to the loudspeakers by transforming it into a high voltage/low current signal, more suitable for traveling long distances.

Distributed amplification systems involve separating the parts of the amplifier and distributing them to remote physical locations that, for some applications, better optimize the wiring and interconnects that make a sound system work.

For instance, if the output stage of the amplifier were placed right at the loudspeaker, there would only be a need for a few inches of loudspeaker cable. In order to avoid having to run AC power to all loudspeaker locations, a central DC power supply can be used to drive many amplifier sections.

The central supply can be located near the AC power source, and the DC output coupled to the amplifier sections through appropriate cabling.

With Live Sound, You Can Make Anyone Sound Good

A free subscription to Live Sound International is your key to successful sound management on any scale — from a single microphone to a stadium concert. Written by professionals for professionals, each issue delivers essential information on the latest products specs, technologies, practices and theory.
Whether you’re a house monitor engineer, technical director, system technician, sound company owner, installer or consultant, Live Sound International is the best source to keep you tuned in to the latest pro audio world. Subscribe today…it’s FREE!!

Commenting is not available in this weblog entry.

Audio Central