Sign up for ProSoundWeb newsletters
Subscribe today!

Forums Presented By: 
In The Studio: How To Build A Guitar Amp Isolation Box
A video and additional guidlines for a solution that keeps the levels from waking up the baby next door...
+- Print Email Share RSS RSS

This article is provided by Bobby Owsinski.

 
OK, you live in an apartment or have some neighbors with sensitive ears so you can’t crank up that Marshall to get your sound.

What you really need is an isolation box to keep the level from waking up the baby next door. Here’s a pretty good video on how to make a guitar amp isolation box, with some caveats.

The layering technique that’s described definitely works, but I’d replace the acoustic foam with some Rockwool or Owens Corning 703. This is the same stuff that’s used in recording studios and if you use Rockwool, it’s a lot cheaper and much more effective than acoustic foam. You can find out a lot more about what it is and where to find it from this post on acoustic treatment, or from The Studio Builder’s Handbook.

Remember:

1) Make sure that the seal on the box is absolutely tight for max isolation. Air is like water and if any can leak out, there goes your isolation.

2) If you place a combo amp inside, it’s going to heat up because there’s no place for the hot air to escape, which can end up causing some major damage. You’re better off using just a speaker cabinet inside.

2A) Players tend to crank their amp up all the way when you get as much isolation as an iso box can offer, but be careful. It’s really easy to overheat your amp head even if it’s not in the box. Once again, this can cause considerable damage.

 

Bobby Owsinski is an author, producer, music industry veteran and technical consultant who has written numerous books covering all aspects of audio recording. For more information be sure to check out his website and blog.


Commenting is not available in this weblog entry.