Sign up for ProSoundWeb newsletters
Subscribe today!

Church Sound: 10 Tips For Improving The Monitor Mix Prior To Sunday
+- Print Email Share RSS RSS

Provided by Sennheiser.

 

The worship mixer’s job is executed in the mix position during worship, but its success is mostly established outside the mix position, prior to worship.

1. Know The Music Beforehand
Get whatever rehearsal music media is available to the worship team for review (legally). Learn the arrangements by listening during the week. Not only will your mixes come together quicker for each song, you’ll also anticipate things like guitar solos or false endings before they happen—not just after they’ve already begun.

Does it really make sense when everyone on the stage knows the songs and arrangements thoroughly, but the sound tech does not?

2. Host A Pre-Production Meeting
Meet with the music/worship and production teams well in advance of each planned service. Reviewing plans and expectations can ensure an appropriate audio setup, and can avoid potentially tough sound reinforcement surprises.

Example: the worship department requests three wireless lavalier or headworn systems for a worship service. At sound check, they are placed on three actors and the tech quickly finds they’re not actors at all… they’re singers, and they’re asking for their vocals in the monitors! If they are omnidirectional it’s a tough situation at best, and practically impossible in many environments.

Now, the worship department may have requested the drama-style mics because the presentation or mood doesn’t suit the normal handheld vocal miking approach. But they didn’t anticipate the technical disaster that comes with their request. (Is it really their job to understand all the tech stuff?) Heading this surprise off at an advance meeting allows the audio tech to suggest a better miking technique, such as normal handheld vocal mics or possibly cardioid headworn mics.

Our point here is not about which mic technique is right for this application, it is that regardless of the chosen solution or compromise, it can be sorted out in advance – not at sound check.

3. Check RF Performance
If any wireless microphones, wireless personal monitor systems, wireless assistive listening systems or any other RF devices are used in the worship space, they must be properly installed and their frequencies coordinated for compatibility. Assuming proper installation, antenna orientation, and frequency coordination have been accomplished, it remains wise to periodically check RF performance. New sources of interference and other surprises are better found during testing—without an audience!

To properly check the systems, turn on all RF devices that will be on during worship, and turn on any equipment in close proximity to the RF devices. Portable transmitters and receivers should not be clustered together for the test—piling them together on a desk or other surface at the sound booth is convenient, but a common mistake. They should be at least several feet apart, and located onstage or in a general area where they will be used.

The outputs of all devices should be auditioned over the PA or with headphones (RF mics), on headphones or earphones (wireless personal monitor receivers), or the receiver/transducer that will be used by the worshipper (assistive listening device).

Note: It can be alternately argued that piling all portable RF devices together for an RF test/sound check can actually be a wise move as it creates a worst case scenario.

4. Perform System Checks
Verify the PA system is in working order before Sunday morning. A brief walk/listen check a day (or a few) in advance can confirm that all PA zones/loudspeakers are working with no failures, and it’s wise to check other output zones too, like lobby, overflow and monitor sends. A blown horn driver in the main PA cluster is not easy to resolve at 7:45 a.m. on Sunday!


Commenting is not available in this weblog entry.